How high to hang curtain rods with crown molding?
It’s all about the balance. If you don’t have enough molding, hanging your curtain rods too high will visually make your room look too tall. But if you add too much molding, the room will look too narrow.
To find the perfect balance, measure your window and add one-quarter inch to each side. This will give your curtain rods plenty of room to hang without bumping into any molding. Aesthetic details matter, and when you have crown molding around your windows, it’s a detail worth paying attention to.
Consider the size of the molding and whether you want to hang your curtain rod into the nook created by the molding. You could buy molding caps or molding tape to cover the ends of your curtain rod if you want a clean look.
How to hang curtain rods with crown molding?
If your windowsills are flush with the molding, you’ll want to add 1/2” to the length of your curtain rods. For example, if you plan to hang your curtain rod 16-1/2” above the floor, add 17” to your measurement.
Don’t forget to add this length to both sides of the window. You’ll also need to add 1/2” to the length of your curtain rod or you� If you want to hang curtain rods with crown molding, start by installing the molding and then screwing the brackets to the wall. Then, measure the distance between the wall studs and the brackets.
Finally, add the rod length plus the brackets’ overhang (you’ll want to add an extra 1/2 inch or so).
How to hang curtain rods with crown molding without nails?
If you prefer not to use nails to install curtain rods with crown molding, you could opt to secure them with small plastic clips. These clips have a U-shaped design and fit snugly over the end of the curtain rod and the molding. They’re very secure and come in a variety of colors and styles.
If you want to hang curtain rods with molding without using nails, you will need to use a special type of molding clip to secure the molding to the wall. These clips usually come with a metal clamp that holds onto the molding and a small screw that is used to tighten the clamp around the molding.
You will need to know the exact depth of the wall where you want to hang your rod to make sure the molding clips are long enough to reach the wall.
How long to hang curtain rods with crown molding?
The length of the curtain rod you choose should match the length of your windows. We recommend adding two or three extra inches of space on each end for molding and securing the ends. You can also use a longer curtain rod than you need to account for the extra length of the molding.
The length of your curtain rods will depend on the length of your molding. Be sure to measure the length of your molding and the length of your window and add an extra half-inch for each end. You can hang your curtain rod with the ends even with the molding or slightly proud of the molding.
How to hang curtain rods with crown molding nails?
To hang curtain rods with crown molding nails, first mark the location of the screw holes on the wall where you want to hang your curtain rods and use a level to make sure they’re plumb. Screw the curtain rods into the wall using the provided screws and nuts, being sure to mark the screw holes on the back of the curtain rod to ensure the nuts are lined up correctly. When everything is in place, use the provided small nails to attach the molding to the wall over There are a couple different ways to hang curtain rods with crown molding. The first option is to use small nails or metal brackets. These small nails are thin and flat, and they’re easy to hammer into the wood. For best results, use small nails for your curtain rods and eaves. Use a small nail for each curtain rod.
